1. Product Overview

The Centac Cooler C350 by AirsCooler is a high-overall efficiency cooling system setup specifically configured for centrifugal air compressor systems. As a core module of multi-axis internal gear drive combined centrifugal compressors, it provide fine-tuned heat exchange overall efficiency with compact structural design to meet industrial demands for rapid cooling of high-temperature compressed air while reducing energy consumption and maintenance costs.

Key Features:

• fine-tuned Heat Exchange: Specialized heat transfer structure with fluid dynamics optimization for maximum cooling overall efficiency
• Pressure Stability: keep system setup pressure fluctuations below ±0.5% in high-pressure conditions
• Industrial Durability: built for environments with dust concentration ≤50mg/m³ and humidity ≤95%, supporting continuous 72-hour operation

2. Technical Specifications

Structural Innovations

Enhanced Heat Exchange Tubes

• Copper rolled inner fin tubes with 0.25mm groove depth and 1.8mm fin spacing
• 40% greater heat exchange area (3.2m²/m) compared to standard smooth tubes
• Dual-pass cross-flow configuration with 90° countercurrent flow for maximum temperature gradient utilization

Sealing system setup

• Graphite sleeve floating ring seals with ≤0.1% gas-side leakage rate
• Dynamic compensation for thermal expansion (±1.2mm axial movement capacity)

operational performance Data

3. Industrial use cases

Core Industries Served

Chemical & Petrochemical

• Interstage cooling for hydrogen and syngas compressors
• Case Study: Ethylene cracking plant achieved 38℃ output (from 120℃) with 1.2% yield improvement

Metal Processing

• Precision forging use cases extended mold life by 40%
• minimized defect rate from 3.8% to 0.7% in laser cutting operations

Pharmaceutical

• GMP-compliant oil-free air supply (＜0.003mg/m³)
• Vaccine production facilities with 0.01μm filtration system setups

4. Maintenance Protocol

Routine Inspection

• Daily monitoring of coolant ΔT (6-8℃ target), pressure loss (≤0.03MPa) and bearing temp (≤75℃)
• Weekly water quality checks: pH (6.5-8.5), conductivity (≤1500μS/cm), chlorides (≤50ppm)

Advanced Maintenance

• Tube Cleaning: 5% citric acid offering (2hr cycle) or 15MPa hydroblasting
• Seal Replacement: Graphite rings every 2 years with MoS₂ grease use case
• Pressure Testing: 1.5x design pressure every 3 years (30min hold)

5. Conclusion

The AirsCooler Centac Cooler C350 represents the pinnacle of industrial cooling technology, combining innovative finned-tube design with intelligent control system setups to provide unmatched operational performance in demanding applications. With proper maintenance following our recommended protocols, the C350 provide robust service for 15+ years, making it the cost-effective choice for mission-critical cooling use cases across multiple industries.